Sharp Zaurus Sl 5600 Poodle

Dmesg

<5>Linux version 2.6.24 (koen@bitbake) (gcc version 4.1.2) #1 PREEMPT Sun Aug 3 20:28:43 CEST 2008
<4>CPU: XScale-PXA250 [69052904] revision 4 (ARMv5TE), cr=0000397f
<4>Machine: SHARP Poodle
<4>Ignoring unrecognised tag 0x00000000
<4>Memory policy: ECC disabled, Data cache writeback
<7>On node 0 totalpages: 8192
<7>  DMA zone: 64 pages used for memmap
<7>  DMA zone: 0 pages reserved
<7>  DMA zone: 8128 pages, LIFO batch:0
<7>  Normal zone: 0 pages used for memmap
<7>  Movable zone: 0 pages used for memmap
<6>Memory clock: 99.53MHz (*27)
<6>Run Mode clock: 199.07MHz (*2)
<6>Turbo Mode clock: 398.13MHz (*2.0, active)
<4>CPU0: D VIVT undefined 5 cache
<4>CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
<4>CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
<4>Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
<5>Kernel command line: console=ttyS0,115200n8 console=tty1 noinitrd root=/dev/mtdblock2 rootfstype=jffs2  fbcon=rotate:1 dyntick=enable quiet
<4>PID hash table entries: 128 (order: 7, 512 bytes)
<4>Console: colour dummy device 80x30
<6>console [tty1] enabled
<6>Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
<6>Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
<6>Memory: 32MB = 32MB total
<5>Memory: 29856KB available (2276K code, 237K data, 76K init)
<7>Calibrating delay loop... 397.31 BogoMIPS (lpj=1986560)
<4>Mount-cache hash table entries: 512
<6>CPU: Testing write buffer coherency: ok
<6>net_namespace: 64 bytes
<6>NET: Registered protocol family 16
<4>Sharp Scoop Device found at 0x10800000 -> 0xc2800000
<6>NET: Registered protocol family 2
<6>Time: oscr0 clocksource has been installed.
<7>Switched to high resolution mode on CPU 0
<6>IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
<6>TCP established hash table entries: 1024 (order: 1, 8192 bytes)
<6>TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
<6>TCP: Hash tables configured (established 1024 bind 1024)
<6>TCP reno registered
<6>LoCoMo Chip: 7649
<6>pxa25x: CPU frequency change support initialized (powersave tables)
<6>JFFS2 version 2.2. (NAND) (SUMMARY)  © 2001-2006 Red Hat, Inc.
<6>io scheduler noop registered
<6>io scheduler anticipatory registered (default)
<4>Console: switching to colour frame buffer device 60x53
<6>pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART
<6>console [ttyS0] enabled
<6>pxa2xx-uart.1: ttyS1 at MMIO 0x40200000 (irq = 21) is a BTUART
<6>pxa2xx-uart.2: ttyS2 at MMIO 0x40700000 (irq = 20) is a STUART
<6>pxa2xx-uart.3: ttyS3 at MMIO 0x41600000 (irq = 7) is a HWUART
<6>loop: module loaded
<5>Sharp SL series flash device: 800000 at 0
<5>Using static partision definition
<5>Creating 1 MTD partitions on "sharpsl-flash":
<5>0x00120000-0x007f0000 : "Boot PROM Filesystem"
<6>NAND device: Manufacturer ID: 0x98, Chip ID: 0x76 (Toshiba NAND 64MiB 3,3V 8-bit)
<6>Scanning device for bad blocks
<5>Creating 3 MTD partitions on "sharpsl-nand":
<5>0x00000000-0x00700000 : "System Area"
<5>0x00700000-0x01d00000 : "Root Filesystem"
<5>0x01d00000-0x04000000 : "Home Filesystem"
<6>pxa2xx_udc: version 30-June-2007
<4>WARNING: at arch/arm/mach-pxa/clock.c:69 clk_disable()
<4>[<c001ff28>] (dump_stack+0x0/0x14) from [<c002737c>] (clk_disable+0x34/0xb0)
<4>[<c0027348>] (clk_disable+0x0/0xb0) from [<c015674c>] (udc_disable+0x54/0x68)
<4> r5:c02699b0 r4:f2600000
<4>[<c01566f8>] (udc_disable+0x0/0x68) from [<c0015328>] (pxa2xx_udc_probe+0x164/0x25c)
<4> r5:c0258880 r4:c02699b0
<4>[<c00151c4>] (pxa2xx_udc_probe+0x0/0x25c) from [<c0146438>] (platform_drv_probe+0x20/0x24)
<4>[<c0146418>] (platform_drv_probe+0x0/0x24) from [<c0144b34>] (driver_probe_device+0x100/0x1b8)
<4>[<c0144a34>] (driver_probe_device+0x0/0x1b8) from [<c0144d4c>] (__driver_attach+0x84/0xe4)
<4> r7:c026993c r6:c0144cc8 r5:c0258880 r4:c0258924
<4>[<c0144cc8>] (__driver_attach+0x0/0xe4) from [<c0143e38>] (bus_for_each_dev+0x48/0x80)
<4> r5:c1c17ed4 r4:00000000
<4>[<c0143df0>] (bus_for_each_dev+0x0/0x80) from [<c0144950>] (driver_attach+0x20/0x28)
<4> r7:00000000 r6:00000000 r5:c0269944 r4:c026993c
<4>[<c0144930>] (driver_attach+0x0/0x28) from [<c01441f0>] (bus_add_driver+0x74/0x1c4)
<4>[<c014417c>] (bus_add_driver+0x0/0x1c4) from [<c0145038>] (driver_register+0x84/0x8c)
<4> r8:c1c16000 r7:00000000 r6:c0018870 r5:00000000 r4:c026993c
<4>[<c0144fb4>] (driver_register+0x0/0x8c) from [<c01466d4>] (platform_driver_register+0x6c/0x88)
<4> r4:c0269920
<4>[<c0146668>] (platform_driver_register+0x0/0x88) from [<c0146c68>] (platform_driver_probe+0x1c/0xa4)
<4>[<c0146c4c>] (platform_driver_probe+0x0/0xa4) from [<c00151ac>] (udc_init+0x28/0x40)
<4> r6:c0018870 r5:00000000 r4:c0019404
<4>[<c0015184>] (udc_init+0x0/0x40) from [<c00087d0>] (kernel_init+0xb4/0x27c)
<4>[<c000871c>] (kernel_init+0x0/0x27c) from [<c0034888>] (do_exit+0x0/0x7f8)
<6>input: LoCoMo keyboard as /class/input/input0
<6>input: Corgi Touchscreen as /class/input/input1
<6>power.c: Adding power management to input layer
<6>sa1100-rtc sa1100-rtc: rtc core: registered sa1100-rtc as rtc0
<6>I2C: i2c-0: PXA I2C adapter
<7>min dma period: 1157600 ps, new clock 398131 kHz
<7>min dma period: 1157600 ps, new clock 398131 kHz
<6>Registered led device: locomo:amber
<6>Registered led device: locomo:green
<6>TCP cubic registered
<6>NET: Registered protocol family 1
<6>XScale DSP coprocessor detected.
<6>sa1100-rtc sa1100-rtc: setting system clock to 1970-01-01 00:00:04 UTC (4)
<4>VFS: Mounted root (jffs2 filesystem) readonly.
<6>Freeing init memory: 76K
<4>mmc0: unrecognised SCR structure version 1
<6>mmc0: new SD card at address 3b49
<6>mmcblk0: mmc0:3b49 SD512 490496KiB 
<6> mmcblk0: p1
<4>Empty flash at 0x0012e3fc ends at 0x0012e400
<4>Empty flash at 0x010d31f8 ends at 0x010d3200
<6>Bluetooth: Core ver 2.11
<6>NET: Registered protocol family 31
<6>Bluetooth: HCI device and connection manager initialized
<6>Bluetooth: HCI socket layer initialized
<6>Bluetooth: L2CAP ver 2.9
<6>Bluetooth: L2CAP socket layer initialized
<6>Bluetooth: HIDP (Human Interface Emulation) ver 1.2
<6>NET: Registered protocol family 23
<6>IrCOMM protocol (Dag Brattli)
<6>Bluetooth: RFCOMM socket layer initialized
<6>Bluetooth: RFCOMM TTY layer initialized
<6>Bluetooth: RFCOMM ver 1.8
<6>ASoC version 0.13.1
<6>wm8731: WM8731 Audio Codec 0.13
<6>asoc: WM8731 <-> pxa2xx-i2s mapping ok

Cpuinfo

Processor    : XScale-PXA250 rev 4 (v5l)
BogoMIPS    : 397.31
Features    : swp half thumb fastmult edsp 
CPU implementer    : 0x69
CPU architecture: 5TE
CPU variant    : 0x0
CPU part    : 0x290
CPU revision    : 4
Cache type    : undefined 5
Cache clean    : undefined 5
Cache lockdown    : undefined 5
Cache format    : Harvard
I size        : 32768
I assoc        : 32
I line length    : 32
I sets        : 32
D size        : 32768
D assoc        : 32
D line length    : 32
D sets        : 32

Hardware    : SHARP Poodle
Revision    : 0000
Serial        : 0000000000000000